Porsche 928 Workshop Manual page 744

928
Automatic Transmission / Conrrols. Case
37
a
REMOVING AND INSTALLING SELECTOR LEVER COVER FRAME
a
At the beginning of standard production covet
frames without locks were used. These frames
can be pried out of the center console wirh a
suitable screwdriver.
Removal of the new version with locks, on rhe
other hand, requires unlocking both locking bars
1 -
a 2-
ATIAYb?--.
1
2
c_ n
f.
,.'.
*
pm: -- I,,, bc:+-
. '
Jl p. ,
.-. ,/
.2'
/ ., ,r
\
_-y: ~
.
L
Cover frame without lock
(old version)
Cover frame wirh lock
(new version)
3. Move selector lever to position "R". disconnect
gate and push forward as far as possible,
4. Push front locking bar forward against stop with
a suitable tool (e. g. scribe).
5. Move selector lever to position "P" and press
out cover frame carefully with a suirable screw-
driver applied at the left rear comer.
Removing
1. Remove selector lever handle and rake off
rubber cover.
2. Move selector lever to position "1" and push
rear locking bar forward against stop with a
suitable tool (e.g. scribe).
hinted in Germany - IV, 1980 Removing and Installing Selectot Lever
Cover Frame
37 - 10 a