928
Clutch,
Controls
30
REMOVING
AND INSTALLING
CLUTCH
PEDAL
Removing
1. Move seat back and steering wheel up to make
procedures easier. Remove shelf if applicable.
2. Disconnect return spring on brake pedal. Remove
shafts for brake and clutch push rods.
mp
-w-y 7
', ,._.: '"
3. The guide rod for clutch power spring has an
assembly bore. Operate clutch pedal far enough
(press down) until bore has cleared the bearing.
Insert 3 mm dia. wire through bore (in this
positionl
to take spring force off of pedal.
4. Remove complete clutch power spring/guide
rod. This requires removing the retainer,
pressing guide rod off clutch pedal and taking
the assembly out of console.
5. Remove brake and clutch pedals after sliding
out the bearing shaft.
a
Printed in Germany
VII, 1983
Removing and Installing Clutch Pedal
30.2e