Porsche 928 Workshop Manual page 778

37
Automatic Transmission / Controls. Case 028
11. Turn transmission until inpur shaft faces up
12. Measure axial play of gear assembly. It should
be0.4to0.6mm.
insrall fear converrer housing with gasket and
tighten four mounting bolts to specified torque.
Check distance from upper edge of input shaft
to upper edge of stator shaft with a deprh
gauge. This distance is "A".
Pull up input shaft against the stop and repeat
measurement. This dwance is "B".
Axial play will be the dlfference between
'.A" a"d "B,',
Adjust axial play to 0. 4.. 0. 6 mm by using
shims of pertinent thickness on rhe input shafr
Prior to checking the axial play of the gear assembly
ir will be essential co adjust the bearing assembly
and tighten rhe dnve pinion nut IO specified rorque.
13. Arrach rear converter housing (see page 37 - 21).
14. Install pressure pins for B 1 and B 2
a
a
a
A - Pressure pins
a
37 - 42 Disassembling and Assembling Transmission
Printed in Germany