Porsche 928 Workshop Manual page 890

39
Dtfferenrial / Transaxle System 928
-..
Determining Distance X
1. Crankshaft musr contact thrusr beating in
direcrion of transmission. Pry flywheel with
a lever until end play of crankshaft is
elimmated.
I
I
2. Determine distance A, by using a ruler and
measuring distance from engine flange 10
flywheel mating surface.
i 3
Note
Remember thickness of ruler when measuring.
Example,
Measured value 6.1 mm
Ruler thickness
+ 5.5mm
Disrance A
12.2 mm
3. Push coupling on to drive shaft and mount
transmission on central tube. Tighten bolts
to specified totque.
4. screw in coupling screws by hand (finger tight).
5. Push drive flange with bushing, bur wirhour
shims, on to drive shaft and insrall circlip.
6. Use a suitable lever and push drive shaft on
drive flange far enough forward so that drive
shaft tests on screws on shaft groove.
I. Tighten screw for coupling to specified torque.
39 - 52 Adjusting Drive Plate
Printed in Germany
(Auromaric Transmission)