Install Sd Card; Equipment Required; Installation Procedure - Honeywell Thor VM1 User Manual

Install SD Card

An SD card slot is provided for storage expansion.

Equipment Required

The following equipment is user-supplied:
•
•
•

Installation Procedure

1. For convenience, the Thor VM1
2. If the Thor VM1 remains in the
3. Shutdown the Thor VM1.
4. Place the Thor VM1 face down on a
5. Using a #2 Phillips bit loosen the
6. Locate the SD card installation slot.
7. Slide the SD card into the slot. The label side (front) of the SD card
8. Reattach the access panel, torquing the screws to 4-5 inch pounds.
9. If removed, reinstall the Thor VM1 in the dock.
10. Restart the Thor VM1.
11. When using Windows explorer to view My Computer, the SD card is
114
Torquing tool capable of measuring inch pounds
SD card - The following commercially available SD cards are recommended:
◦ Transcend® 2GB Industrial SD card (80X Speed) - TS2GSD80I
◦ ATP 4GB Industrial Grade SDHC card - AF4GSDI
#2 Phillips screwdriver bit
can be removed from the dock,
though it is not necessary.
dock, disconnect the power cable
from the dock.
stable surface.
M3 screws and then remove the
tethered access panel with the SIM
label. This panel is on the left hand
side when the Thor VM1 is face down with the top away from the user.
faces toward the back of the Thor VM1.
identified as Removable Disk, usually Drive D:.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide