Honeywell Thor VM1 User Manual page 130

8. Locate the retaining tab on the
9. Remove the old battery and set it aside.
10. Inspect the battery well to verify the two foam pads are still in place.
11. Align the wiring connector on the new UPS battery with the connector on the Thor
12. Place the UPS battery into the well. Note the orientation of the battery in the
13. Position the front panel so the tab on the back of the front panel lines up with the
14. Gently press the front panel into place.
15. Tighten the fourteen (14) captive M3 screws. In the order shown in the top figure
16. Reinstall the Thor VM1 in the dock.
17. When the Thor VM1 is placed in the powered dock, the UPS battery automatically
18. Restart the Thor VM1.
120
wiring connector for the UPS
battery. Press on the tab and gently
disconnect the UPS battery wiring
from the Thor VM1.
VM1. Gently press the connector into place until the retaining tab snaps into place.
illustration below. The flat surface of the battery points toward the bottom of the
Thor VM1. Make sure all wires are inside the battery well so they are not pinched
when the front panel is reinstalled.
Slot on
Wiring Connector
Thor VM1
on Thor VM1
slot on the Thor VM1. Be sure the two wiring connectors are also aligned.
above, use a #2 Phillips bit and torque the screws to 6-7 inch pounds.
reconnects. The UPS battery automatically begins charging from the powered dock.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Wiring Connector
with Release Tab
Slot on
Front Panel
Wiring Connector
on Front Panel