Honeywell Thor VM1 User Manual page 100

Screen Blanking
Prerequisite: The steps outlined in either
Connection),
60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Top of Lid)
pleted.
Screen blanking is accomplished by either a Screen Blanking Box or a user supplied
switch.
Caution: For installation by trained service personnel only.
Fuse Requirements
Warning: For proper and safe installation, the input power lead to the
Note: For North America, a UL Listed fuse is to be used.
Screen Blanking Cable
Refer to
When routing any additional cables for screen blanking:
•
•
•
•
•
•
Honeywell Screen Blanking Box Cable
An optional Honeywell Screen Blanking Box Cable is available.
90
60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid)
Screen Blanking Box requires a 3 Amp maximum time delay
(slow blow) high interrupting rating fuse.
Screen Control to configure the Thor VM1 for screen blanking.
Route the cable the shortest way possible removing any left-over cable
Fuses and cabling are user supplied. Therefore, route these cables so they are
protected from physical damage and from surfaces that might exceed the cable's
rated temperature threshold.
Cable should be protected from physical damage from moving parts
Do not expose the cable to chemicals or oil that may cause the wiring insulation to
deteriorate
Always route the cable so that it does not interfere with safe operation and
maintenance of the vehicle.
Provide mechanical support for the cable by securing it to the vehicle structure at
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
12-48 VDC Vehicles (10-60 VDC Direct
or
have been com-