Insert An Sd Card; Equipment Required; Installation Procedure - Honeywell Thor VM1A User Manual

Defroster Setting
Defroster enabled
temperature
Defroster State
Temperature
Manual/Automatic
Defroster On/Off

Insert an SD Card

You can use an SD card to increase file storage capacity or to install software. Hon-
eywell recommends the use of Single Level Cell (SLC) industrial grade SD or SDHC
memory cards with the computer for maximum performance and durability.
Note: Format the memory card before initial use.

Equipment Required

The following equipment is user-supplied:
•
•
•

Installation Procedure

1. For convenience, the computer can be removed from the dock, though it is not
2. Press and hold the Power button until the options menu appears. Tap Power
3. If the computer was removed from the dock, place the computer face down on a
4. Using a #2 Phillips bit loosen the M3 screws and then remove the access panel
Thor VM1A Vehicle-Mounted Computer
Torque tool capable of measuring inch pounds
SD card up to 512 GB
#2 Phillips screwdriver bit
necessary. If the computer remains in the dock, disconnect the power cable
from the dock.
Off.
stable surface.
with the SD label. This panel is on the left hand side when the computer is face
down with the top away from the user.
Description
Set the temperature (°C) that the computer must fall to before the
system determines cold storage entry and defroster use.
Shows current state of defroster, On or Off.
Shows detected LCD window temperature
Tap the button to switch between Automatic mode or Manual
mode. To learn more about the modes, see
Works on page 25 and Manual mode
Tap the button to switch between On and Off.
How Automatic Mode
on page 26.
27