Autoon - Honeywell Thor VM1 User Manual

AutoOn

(Start) > Control Panel > AutoOn (Classic view)
Select the desired Ignition Control / Auto On behavior.
Standard
The Thor VM1 is turned on and off manually by the user using the power button on the
front of the device.
•
•
•
When the Thor VM1 is on, the behavior of the power button press is configurable using
the control panel.
Ignition Control
The Thor VM1 is turned on automatically when a signal is received via the Ignition Input
wire, which is part of the DC Power Cable.
•
•
When the vehicle ignition is turned off, this is treated the same as a power button press.
The behavior of the power button press is configurable using the control panel.
Note: When the UPS battery has been depleted or disconnected (the Thor VM1 is first powered
out of the box, the front panel has been replaced, etc.) power the Thor VM1 manually by
pressing the power button. After the initial power up, the Thor VM1 powers on
automatically when the vehicle ignition is turned on and Ignition Control is enabled.
126
The power switch on the dock must be On and the Thor VM1 connected to external
power.
In the absence of external power the Thor VM1 can operate from a sufficiently
charged UPS battery.
The Ignition Input wire, which is part of the DC Power Cable, is left disconnected.
The power switch on the dock must be On.
The Ignition Input wire is connected to an appropriate source that provides a signal
when vehicle ignition is turned on. Please see
instructions.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Connect Power for cautions and wiring