Connect Serial Device; Connect Headset Cable - Honeywell Thor VM1 User Manual

Connect Serial Device

Note: Pin 9 of the COM port is configured to provide +5V.
See
1. Seat the cable end connector firmly over the serial COM port on the dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM1 with
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM1 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.

Connect Headset Cable

The CANbus/Audio connector supports a headset adapter cable or a CANbus cable. The
Thor VM1 does not support connecting audio and CANbus simultaneously.
See
1. Seat the D15 cable end connector firmly over the CANbus/Audio Connector on the
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
104
COM1 and COM2 Connector
Headphones
Microphone
CANbus / Audio Connector
dock.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
for connector pinouts.
Strain Relief Cable
To Audio cable
for connector pinouts.
Clamps.
To headset
To Audio
connector
on dock