Honeywell Thor VM1 User Manual page 196

WPA/LEAP
To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set EAP Type to LEAP
3. Set Encryption to WPA TKIP
4. Set Auth Type as follows:
To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for
encryption and complete other entries as detailed in this section.
See
To use Stored Credentials, click on the Credentials button. No entries are necessary for
Sign-On Credentials as the user will be prompted for the Username and Password when
connecting to the network.
Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
Enter the password.
Click OK then click the Commit button.
186
• If the Cisco/CCX certified AP is configured for open authentication, set the Auth
Type radio parameter to Open.
• If the AP is configured to use shared key or passphrase, set the Auth Type radio
parameter to Shared.
• If the AP is configured for network EAP only, set the Auth Type radio parameter to
LEAP.
Sign-On vs. Stored Credentials
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
for information on entering credentials.