Honeywell Thor VM1 User Manual page 151

•
•
Create and print the label.
Scan the Thor VM1 Bluetooth address bar code label with the Bluetooth bar code
reader.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps
and LED flashes.
Note: After scanning the Thor VM1 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth bar code reader, the devices are currently paired.
See
Bluetooth Beep and LED Indications
Beep Type from Bluetooth Device
Acknowledge label
Label rejected
Transmission error
Link successful
Link unsuccessful
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep (1 Hz)
Green LED blinks once a second
Upon startup, if the Bluetooth device sounds a long tone, this means the Bluetooth
device has not passed its automatic Selftest and has entered isolation mode. If the
Bluetooth device is reset, the sequence is repeated. Contact
assistance.
Bluetooth Printer Setup
The Bluetooth managed device should be as close as possible, in direct line of sight,
with the Thor VM1 during the pairing process.
1. Open the Bluetooth EZPair Panel.
2. Tap Discover. Locate the Bluetooth printer in the Discovery panel.
3. Tap and hold the stylus (or double-tap) on the Bluetooth printer ID until the right-
Select Pair as Printer to pair the Thor VM1 with the Bluetooth managed printer.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Bar code type must be Code 128.
FNC3 character followed by string Uppercase L, lowercase n, lowercase k, uppercase
B and then the Bluetooth address (12 hex digits, no colons). For example,
LnkB0400fd002031.
Bluetooth Beep and LED
mouse-click menu appears.
Indications.
Behavior
1 beep
2 beeps at low frequency
Beep will sound high-low-high-low
Beep will sound low-medium-high
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Paging
Disabled indication
Technical Assistance for
141