Install Sd Card; Equipment Required; Installation Procedure - Honeywell Thor VM2 User Manual

Install SD Card

An SD card slot is provided for storage expansion.

Equipment Required

The following equipment is user-supplied:
• Torquing tool capable of measuring inch pounds
• SD card - The following commercially available SD cards are recommended:
» ATP 2GB Industrial Grade SDHC card - AF2GSDI-5ADXX
» ATP 4GB Industrial Grade SDHC card - AF4GSDI-5ACXX
®
» SanDisk 2GB SDHC card - SDSDB-2048
®
» SanDisk 4GB SDHC card - SDSDB-004G
• #2 Phillips screwdriver bit

Installation Procedure

1. For convenience, the Thor VM2 can be removed
from the dock, though it is not necessary.
2. If the Thor VM2 remains in the dock, disconnect the
power cable from the dock.
3. Place the Thor VM2 in Suspend by pressing the
Power button.
4. Place the Thor VM2 face down on a stable surface.
5. Using a #2 Phillips bit loosen the M3 screws and
then remove the tethered access panel with the
SIM label. This panel is on the left hand side when
the Thor VM2 is face down with the top away from
the user.
6. Locate the SD card installation slot.
7. Slide the SD card into the slot. The label side (front) of the SD card faces toward the back of the
Thor VM2.
8. Reattach the access panel, torquing the screws to 4-5 inch pounds.
9. If removed, reinstall the Thor VM2 in the dock.
10. Resume the Thor VM2 from suspend.
11. When using Windows explorer to view My Device, the SD card is identified as SD Card.
4 - 50