Honeywell Thor VM1 User Manual page 101

DB9
Female
1 -6, 9
7 (RTS)
8 (CTS)
Note: Wire colors only apply to optional Honeywell Screen Blanking Box Cable, VM1080CABLE.
Wire colors may vary in a user-supplied cable.
The optional Honeywell Screen Blanking Box Cable, VM1080CABLE, is installed as fol-
lows:
1. Connect the gray wire of the cable to the switched side of the Screen Blanking Box.
2. Connect the black wire of the cable to the unswitched side of the Screen Blanking
3. Connect the D9 serial connector to either COM1 or COM2 serial port on the Thor
User-Supplied Cable
A user-supplied cable can be used as well. Pins 7 and 8 must be connected as detailed
below. No other pins are to be connected.
PIN 5
PIN 8
DB9
Female
1 -6, 9
7 (RTS)
8 (CTS)
The user-supplied cable is installed as follows:
1. Connect the wire from Pin 8 of the cable to the switched side of the Screen Blanking
2. Connect the wire from Pin 7 of the cable to the unswitched side of the Screen
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Function with Screen Blanking Box
Not Used
Connected to Screen Blanking Box, unswitched
side
Connected to Screen Blanking Box, switched
side
Box.
VM1 dock.
PIN 1
PIN 7
Function with Screen Blanking Box
Not Used
Connected to Screen Blanking Box, unswitched
side
Connected to Screen Blanking Box, switched side
Box or to a user-supplied switch.
Blanking Box or to a user-supplied switch.
Wire color
Black (see note)
Gray (see note)
Function with Switch
Not Used
Connected to Switch
Connected to Switch
91