Honeywell Galaxy 18Galaxy Programming Manual page 150

63 - Options (cont'd)
3 = Group Name
This option is used to assign a name of up to 12 characters to each of the groups. This name is assembled
from the character set and/or library options. On selecting the Group Name option, the name currently
assigned to group 1 is displayed. All group names default to Group X (where X is the group number). Use
the A or B keys to move to the required group or directly select it by pressing the required group number;
press the ent key to access the group. On selecting the group, the following details are displayed:
Upper case text.
# to toggle upper case/
lower case/library
The currently assigned name is displayed on the top line - an underscore shows where the next character will
be positioned, and a selection of the alphabet is shown on the bottom line - the cursor flashes on the letter L.
Press the key to erase the characters already assigned to the name.
The A or B keys can be used to move the alphabet left or right until the required character is positioned
underneath the flashing cursor. When the required character is in position press the ent key to copy the char-
acter to the descriptor in the top line. Repeat this procedure to assemble the required Group Name.
Text Case & Library
On entering the Group Name option the alpha-numeric characters are all presented in upper case. Pressing
the # key toggles the characters to lower case.
Pressing the # key when the lower case alphanumeric characters are displayed toggles to the library words.
The words can be viewed using the A or B keys or directly selected using the reference number - refer to
Appendix A - Library. When the required word is displayed, press the ent key to copy it to the name.
NOTE: Library words are a maximum of 12 characters and upper case only.
Galaxy Programming Manual
A2 Group Name
EFG HIJKLMNÖØO P
144
Current Group name