Unsetting the System
Unsetting the System
During the unsetting procedure, initiated by the opening of FINAL or ENTRY zone on a set group, the
system is unset by entering the user code followed by the A key.
•
If the user does not have group choice, all of the groups assigned to the code are instantly unset.
•
If the user has group choice only the group that the FINAL or ENTRY zone is assigned to is
unset; all of the other groups remain set. The system displays the set status of the remaining
groups and prompts for the required groups to be unset. To unset the required groups press the
relevant number keys — the S or P (Set or Part Set) changes to flashing U — and then press the
ent key.
Engineer Unsetting (G8, 18, 60, 128, 500 and 504)
The engineer can only unset a system that was set using the engineer code. The engineer code cannot be used
to unset a system that was set by a user code.
Keyswitch Setting Options
Zones programmed as KEYSWITCH can be used to full set, part set and unset the system. Refer to option
52 = PROGRAM ZONE.
Setting the System with a Keyswitch
The KEYSWITCH starts the setting procedure of each of the groups assigned to zone. At the end of the exit
time, or when the setting procedure is terminated by a FINAL or PUSH-SET zone closing, the ENTRY/
EXIT HORN outputs and keypad buzzers become silent for 4 seconds, then emit 2 long tones to confirm
that the system is set.
NOTE: If the KEYSWITCH has its Part attribute enabled (refer to option 52 = PROGRAM ZONE) then
the KEYSWITCH part sets the system.
Unsetting the System with a Keyswitch
Activating the KEYSWITCH when the group that it is assigned to is set instantly unsets the group. All other
groups which have been "starred" to the KEYSWITCH are not affected and remain set.
Galaxy Programming Manual
8