Honeywell Galaxy 18Galaxy Programming Manual page 100

Galaxy Programming Manual
53 - Program Outputs (cont'd)
42 Illegal Code (Latch) (Galaxy 60, 128, 500, 504 & 512)
The Illegal Code is activated 60 seconds after an entry of a single Dual Code or a code which is entered
outwith the Timer A and/or Timer B times assigned to it in menu option 42.1.4=CODES.User
Codes.Time Zone.
43 Max Tamp (Latch)
The MAX TAMP output is activated when a MAX, MicroMAX or MAX tamper is activated.
3
44 Abort (Latch)
The ABORT output is activated when a valid code is entered during the Abort period on system entry.
45 Unset
The Unset output is activated each time the system (or group) is unset. The default output mode attribute is
programmed as pulse, for two seconds. This can be used to activate a buzzer to notify a user that the system
has been unset, when using an RF fob.
46 Set Late (Latch) (Galaxy 128, 500, 504 & 512)
The Set Late output is activated if the system has not been set by the programmed Monitor time – refer to
option 65.3.1=TIMERS.Autoset.Status.
47 U/S Early (Latch) (Galaxy 128, 500, 504 & 512)
The Unset Early output is activated if the system has been unset before the programmed Monitor time –
refer to option 65.3.1=TIMERS.Autoset.Status.
48 Prewarn (Reflex) (Galaxy 128, 500, 504 & 512)
The Prewarn output is active during the programmed prewarning period of the autoset function. The mode is
Reflex. The Prewarn emits a constant tone if the autosetting of the system can be extended. If an extension
is not possible, the Prewarn output pulses.
49 Autoset (Reflex) (Galaxy 128, 500, 504 & 512)
The Autoset output is activated when the system has been set by the autoset function – refer to option
65.3=TIMERS.Autoset. The default Output Mode attribute is programmed as Reflex, therefore the output
remains active until the system unsets.
NOTE: The Set is also activated when the system autosets.
50 Not Used
94