Honeywell Galaxy 18Galaxy Programming Manual page 160

64 - Assemble Zones (cont'd)
Assemble Zone Example:
Assemble a zone that:
• activates Bells outputs when the system is set,
• activates Link-A outputs when the system is unset,
• generates an alarm condition when the system is part and full set,
• does not generate an alarm condition during the setting and unsetting procedure,
• acts as a terminator when the system is setting,
• logs all activation (in both set and unset states).
Programming:
(Assuming factory default settings)
1. Select option 64 = ASSEMBLE ZONES; press the ent key,
2. Select custom zone (1 = Custom-A, 2 = Custom-B); press the ent key,
3. Outputs is displayed. Press the ent key to select this option,
4. Bells is displayed. Press the # key. Set is displayed,
5. Enter 51. Link-A is displayed. Press the # key. Set is displayed,
6. Press the # key. Unset is displayed,
7. Press the esc key. Outputs is displayed,
8. Press the A key. Status is displayed. Press the ent key to select this option,
9. Unset Disabled is displayed,
10. Press the A key. Entry/ Exit Disabled is displayed,
11. Press the A key. Part Set Disabled is displayed,
12. Press the # key. Part Set Alarm is displayed,
13. Press the A key. Full Set Disabled is displayed,
14. Press the # key. Full Set Alarm is displayed,
15. Press the esc key. Status is displayed,
16. Press the A key. Setting is displayed. Press the ent key to select this option,
17. Begin Set Disabled is displayed,
18. Press the A key. Sets System Disabled is displayed,
19. Press the # key. Sets System Enabled is displayed,
20. Press the esc key. Setting is displayed,
21. Press the A key. Log is displayed. Press the ent key to select this option,
22. Log Disabled is displayed,
23. Press the # key. Log Entry/Exit is displayed,
24. Press the # key. Log 24 Hours is displayed,
25. Press the esc key three times to return to the 64 = ASSEMBLE ZONES display.
Galaxy Programming Manual
154