Codes And Users; Change Duress Codes; Change Master Manager Code - Pyronix ENFORCER V11 Programming Manual

CODES AND USERS?

This function changes the Engineer code, the Master Manager code and adds/changes/deletes any Duress or
Guard codes.
Default codes
User: [None]
Please note: User codes, fobs and keyfobs can only be changed in the Master Manager Menu. Please see
the user manual for more information.
5 Digit Pins?
If enabled, all new codes added to the system will require a minimum of 5 digits.
Please note: Any existing 4 digit codes will still be valid.
Delete Users And Fobs
This will delete all the key fobs and user codes from the system.
Please note: that this will not delete the Master Manager and the Engineer codes.
[2] Duress Code
If the system is unset using a 'Duress' code, a silent 'Duress' or 'Hold Up' signal is sent.
Please note: ACPO policy restricts (it is still OK to use if Police give permission) use of Duress codes for
police call purposes.
[3] Guard Code
A 'Guard code' can be used to unset the system only after an alarm has been activated for a minimum time (see
'Change Timers' Appendix C). The code will arm a system and an output type is available to signal when this code
is used (0058 Guard Code).
[4] Dial Out
A dial code is used to force the panel to dial out the UDL software while in 'Day Mode' (PSTN modem only).
The Master Manager code can be 4, 5 or 6 digits long, or can be assigned to a tag. It may also have the following
functions:
[0] Unset / Set
Flexi Set
If enabled, the default area the device is assigned to, will set. If disabled, the default area will be shown on the
display, and from here other areas can be selected.
5 Digit PINs?
Delete Users and Fobs?

Change Duress Codes?

Change Master Manager Code?

Change Engineer Code?
Master Manager: 2222
[1] Unset Only
ENFORCER V11 PROGRAMMING GUIDE
CODES AND USERS
Engineer: 1111
CHANGE DURESS CODES
CHANGE MASTER MANAGER CODE
[2] Set Only [3] None (menu access)
25