Error Codes - Canon iR6570 Series Portable Manual

Chapter 3
Cause
The combination of characters used in the
search condition fails to make up a correct
search condition.
There must be as many "s as there are "s
The symbol * is not included within
parentheses.
If LDAP of the server and the character code is
version 2 (JIS), there is a character that is not
part of the ASCII code (0x20-0x7E).
The version setting of the server is wrong, and the search cannot be initiated. Check the
settings.
In user mode, the LDAP server settings (server
LDAP version and character code) is set for
version 3; however, the LDAP server is
operating for version 2.

3.2.2 Error Codes

iR5570 / iR6570
Cause
# 001
There is a paper or original jam.
# 003
A communication lasting longer than a specific
period of time (64 min) will cause an error state.
# 005
The target does not respond within 35 sec.
The target is a non-G3 model.
# 009
There is no paper.
The cassette is not fitted properly.
# 011
3-30
Remedy
Check to be sure that the combination of
characters is in keeping with the rule; then, try
once again.
Remove any character that cannot be used;
then, try once gain.
In user mode, set the LDAP server settings so
that the LDAP server version and the character
code are both version 2.
T-3-6
Remedy
Remove the jammed paper or original.
1. Decrease the resolution for transmission.
2. In the case of reception, ask the source to
decrease the resolution or divide the original.
Check to be sure that the target is ready to
communicate; then, try once again.
Check the target.
Supply paper.
Fit the cassette correctly.
0009-7942