Canon iR6570 Series Portable Manual page 91

Code Description
0000 There is an error in the communication
between the main controller PCB and the
CPU of the DC controller PCB.
E248 There is an EEPROM error.
0001 An error has occurred at power-on.
0002 An error has occurred at time of write
operation.
0003 An error has occurred at time of read
operation after write operation.
E315 There is a fault in the image data.
0007 There is a JIBIG encode error.
000d There is a JBIG decode error.
E400 There is an ADF communication error.
0001 There is a check sum error.
0002 There is a reception status error.
0003 There is a reception interrupt error.
E413 There is a fault in the ADF shift motor.
0001 The output of the shift HP sensor is
identified as indicating open.
0002 The output of the shift HP sensor is
identified as indicating closed.
E490 The ADF type is wrong.
0001 The ADF is not of a supported type.
E503 There is an error in the finisher internal communication (finisher).
0002 There is an error in the communication
between the finisher and the saddle unit.
0003 There is an error in the communication
between the finisher and the punch unit.
E505 There is a finisher backup memory error (finisher).
Remedy
- Check the connector for any fault in
connection.
- Replace the DC controller PCB.
- Replace the main controller PCB.
- Replace the EEPROM.
- Replace the reader controller PCB.
- Turn off and then back on the power.
- Check the connector for any fault in
connection.
- Replace the reader controller PCB.
- Replace the ADF controller PCB.
- Check the connector for any fault in
connection.
- Replace the sensor and motor in
question.
- Check the mounting condition of the
area around the cam.
- Replace the ADF with a supported type.
- Check the connection between the
saddle stitcher controller PCB and the
finisher controller PCB.
- Check the communication between the
saddle stitcher controller PCB and the
finisher controller PCB.