Canon iR6570 Series Portable Manual page 77

tighten the mounting screw [1] in hole A.
- If pickup failure occurs, remove the mounting screw
[1], and raise the mounting base [2]; then, tighten
the mounting screw [1] in hole B.
hole A
hole B
F-2-67
2.8.6
Adjusting
Position of the Pickup
Solenoid (SL3, SL4) of
the Cassette 3/4
iR5570 / iR6570
Adjust the position of the solenoid using the two
screws [3] so that the distance from the bottom of the
pickup assembly to A of the roller arm is 36-/+0.5 mm
when [1] and [2] are op-erated.
[2]
[2]
A
F-2-68
[1]
[2]
the
0009-5532
[1]
[1]
[3]
A
2.8.7
Adjusting
Position of the Delivery
Flapper Solenoid (SL5)
iR5570 / iR6570
Adjust the position of the mounting screw [2] using
the screw [2] so that the drive lever [1] is pushed fully
when the solenoid turns on (i.e., when the plunger is
drawn).
[1]
F-2-69
2.8.8
Adjusting
Position of the Right
Deck Pickup Solenoid
(SL6)
iR5570 / iR6570
Adjust the position of the solenoid so that the left edge
of the arm 2 is 57.2 -/+0.5 mm from the center of hole
A of the solenoid mounting base.
F-2-70
Chapter 2
the
0009-5535
[2]
the
0009-5536
[A]
57.2 0.5mm
2-43