Canon iR6570 Series Portable Manual page 92

Code Description
0001 An error has occurred in the data stored in
the backup memory.
0002 There is an error in the punch unit
EEPROM data.
E514 There is a trailing edge assist motor error (finisher).
8001 The home position sensor does not go off
even when the trailing edge assist motor
has rotated for a specific period of time.
8002 The home position sensor does not go on
even when the trailing edge assist motor
has rotated for a specific period of time.
E519 There is a gear change motor error (finisher).
8001 The home position sensor does not go off
even when the gear change motor has
rotated for a specific period of time.
0002 The home position sensor does not go on
even when the gear change motor has
rotated for a specific period of time.
E530 There is a front alignment error. (finisher)
8001 The home position sensor does not go off
even when the front alignment motor has
rotated for a specific period of time.
8002 The home position sensor does not go on
even when the front alignment sensor has
rotated for a specific period of time.
E531 There is a stapling error. (finisher)
Remedy
- Turn off the main power; check the DC
controller PCB and the finisher controller
PCB for wiring; check the 24-V system
fuse; then, turn the main power back on.
- Turn off the main power; check the DC
controller PCB and the puncher controller
PCB for wiring; then, check the 24-V
system fuse; then, turn the main power
back on.
1. Check the trailing edge assist home
position sensor. Is the sensor normal?
2. Check the wiring between the finisher
controller PCB and the trailing edge assist
motor. Is it normal?
3. Check the trailing edge assist
mechanism. Is there a fault?
4. Try replacing the trailing edge assist
motor. Is the problem corrected?
1. Check the gear change home position
sensor. Is the sensor normal?
2. Check the wiring between the finisher
controller PCB and the change motor. Is it
normal?
3. Check the gear change mechanism. Is
there a fault?
4. Try changing the gear change motor. Is
the problem corrected?
1. Check the aligning plate home position
sensor. Is it normal?
2. Check the wiring between the finisher
controller PCB and the aligning plate
front motor. Is it normal?
3. Is there any mechanical obstacle in the
path in which the aligning plate moves?
4. Try replacing the aligning plate front
motor. Is the problem corrected?