Table of Contents
Advertisement
HW1483028
9.3.3 Grease Replenishment/Exchange for L-axis Speed Reducer
9.3.3.1 Grease Replenishment
9
Maintenance and Inspection
9.3
Grease Replenishment/Exchange Procedures
Fig. 9-5: L-axis Speed Reducer Diagram
Grease exhaust port
Hexagon socket head
plug PT3/8
L-axis speed reducer
Replenish the grease according to the following procedure. (Refer to
fig. 9-5 "L-axis Speed Reducer Diagram" .)
1. Make the L-arm vertical to the ground.
2. Remove the hexagon socket head plug PT3/8 from the grease
exhaust port.
3. Remove the hexagon socket head plug PT1/8 from the grease inlet.
• If grease is injected with the exhaust plug on, the grease
will leak inside the motor and may cause a damage. Make
sure to remove the plug before the grease injection.
NOTE
• Do not install a joint, a hose, etc. to a grease exhaust port.
Failure to observe this instruction may result in damage to
the motor due to coming off of an oil seal.
4. Install the grease zerk PT1/8 to the grease inlet. (The grease zerk is
delivered with the manipulator.)
5. Inject grease through the grease inlet using a grease gun.
– Grease type:
– Amount of grease:
– Air supply pressure of grease pump:
– Grease injection rate:
6. Move the L-axis for a few minutes to discharge the excess grease.
7. Wipe the discharged grease with a cloth and reinstall the hexagon
socket head plug PT3/8 to the exhaust port.
Before installing the plug, apply Three Bond 1206C on the thread part
of each plug, then tighten the plug with a tightening torque of 4.9 N•m
(0.5 kgf•m).
8. Remove the grease zerk from the grease inlet and reinstall the
hexagon socket head plug PT1/8.
Before installing the plug, apply Three Bond 1206C on the thread part
of each plug, then tighten the plug with a tightening torque of 4.9 N•m
(0.5 kgf•m).
9-10
Grease inlet
Hexagon socket
head plug PT1/8
Molywhite RE No.00
340 cc
(680 cc for 1st supply)
0.3 MPa or less
8 g/s or less
HW1483028
47/69
Hide quick links:
Advertisement
Table of Contents
