Dhcp Client; Default Gateway; Usb Ip Address; Usb Network Mask - Codan Envoy Reference Manual

Related links:

DHCP Client

The DHCP Client entry sets whether or not there is a DHCP client active on this
control point. Typically, the DHCP client is enabled if the control point is connected
to a computer network that has a DHCP server enabled. If the DHCP client is enabled,
it overrides any IP, network mask or gateway value that may have been entered
manually.
Default value:

Default Gateway

The Default Gateway entry sets the IPv4 address of the default gateway for the
control point. If you have set the DHCP Client entry to Enabled, this entry is
ignored.
Default value:

USB IP Address

The USB IP Address entry sets the IPv4 address for the USB interface on the
control point. The USB interface on the control point can also act as a DHCP server.
CAUTION:
Default value:

USB Network Mask

The USB Network Mask entry sets the network mask for the USB interface on the
control point.
CAUTION:
Default value:

USB DHCP Server

The USB DHCP Server entry sets whether or not there is a DHCP server active on
the USB interface for this control point. The server provides IP addresses to any
IP-based USB devices that have a DHCP client enabled.
CAUTION:
Default value:
E ™ T R
NVOY RANSCEIVER EFERENCE
DHCP Client on page 259
Disabled
192.168.0.1
It is recommended that this setting is not changed.
192.168.234.1
It is recommended that this setting is not changed.
255.255.255.0
It is recommended that this setting is not changed.
Enabled
M
ANUAL
S
ETTINGS
S > C
ETTINGS ONNECTIVITY
259