Alert Tones; Call Status Time; Chain Call Pause - Codan Envoy Reference Manual

Alert Tones

The Alert Tones entry sets whether or not the transceiver gives an alert tone (beep,
or ring if an external alarm is connected) when it receives a message or a non-message
call.
If you want the transceiver to:
•
•
•
Default value:

Call Status Time

The Call Status Time entry sets the maximum length of time a called station has to
respond to a Get Status call with the information requested.
Range: 0 to 255 sec
Default value:

Chain Call Pause

The Chain Call Pause entry sets the length of time the transceiver pauses between
chained calls.
A chain call is started when you hold the
first call defined in the emergency contact that you select, waits the pause time, then
makes the next call defined in the same emergency contact, and so on, until it makes
the last call defined for this emergency contact.
Range: 0 to 60 sec
Default value:
Related links:
E ™ T R
NVOY RANSCEIVER EFERENCE
provide a local alert tone and external alarm when it receives any type of call,
select Normal
not provide a local alert tone or external alarm when it receives a message call,
select Messages do not ring
not provide a local alert tone or external alarm when it receives any type of call,
select Disabled
Normal
10 sec
30 sec
Call types on page 434
Calling on page 45
M
ANUAL
S
ETTINGS
key for 2 sec. The transceiver makes the
S
ETTINGS
> C > G
ALLING ENERAL
233