Rfu 15Way 2.4 Kbit/S Data Modem Interface; Rfu 6Way Mode; Rfu 6Way Speed; Rfu 6Way Startup - Codan Envoy Reference Manual

RFU 15way 2.4 kbit/s Data Modem Interface

The RFU 15way 2.4 kbit/s Data Modem Interface entry sets whether or not this
internal data modem interface is connected to the 15-way port. If you are connecting
to a computer with UUPlus© via serial cable 08-06952-00x, you must set this to
Enabled.
Default value:

RFU 6way Mode

The RFU 6way Mode entry sets the mode in which the RS232 6-way serial port
operates. This entry is only available if you are setting up the 6-way connector on the
RFU for a user-defined peripheral device.
If the port is:
•
•
•
•
Default value:

RFU 6way Speed

The RFU 6way Speed entry sets the data rate of the RS232 6-way serial port. If
available, you should set this to the same speed that is set in the connected peripheral
device.
Default value:

RFU 6way Startup

The RFU 6way Startup entry sets the serial commands that you want to have
performed by the 6-way port following power up.
Typically, this is used for specific commands that are required in a system that uses
CICS commands.
Default value:
E ™ T R
NVOY RANSCEIVER EFERENCE
Disabled
not in use, select None
receiving GPS information, select GPS
controlling and monitoring the transceiver, select CICS
accessing information from a log of radio/telephone interconnect activity, select
Log output
GPS
4800 bit/s
no selection
M
ANUAL
P
ERIPHERALS
E
NTRIES FOR A PERIPHERAL
201