Ale|Selcall Address; Phone Link; Phone Number; Message|Status Type - Codan Envoy Reference Manual

ALE|Selcall address

The address is used to identify the station that you want to call. This address is sent
with the preamble when the call is made. A station that is scanning to detect calls made
to its address responds according to the call system used by the associated HF
network.
NOTE:
Related links:

Phone link

A phone link may be pre-defined and selected when adding a Phone call to a contact.
When you select this phone link, you automatically select all of the details defined in
the phone link, such as its address and the HF network that you use to make calls to
this telephone station. If there is no phone link defined in the transceiver, you will be
prompted for the details of the phone link at the time of the call.

Phone number

The phone number is the number of the telephone that you want to call via the
radio/telephone interconnect at the telephone station. The phone number may be up to
40 characters long (0–9,*#+).

Message|Status type

The Message|Status Type entry for the call information is available when you
select the Message or Get Status call types respectively. If you always want to send
the same message, for example, that you are shutting down for the day and include the
time and your GPS location, you would enter Shutting down, $TIME, $GPS. If
you want to send a different message every time, select Prompt, and you will be
prompted to enter a message at the time of sending the call.
Related links:
E ™ T R
NVOY RANSCEIVER EFERENCE
The ALE|Selcall Address entry is not shown if the call system is
RFDS, or if a valid phone link is selected.
HF networks on page 139
ALE address syntax on page 442
Messages on page 187
Sending recognised keywords with a call on page 454
M
ANUAL
C
ONTACTS
E
NTRIES FOR A CONTACT
161