Emc, Fcc, Cdrh - Agatec EZDigPro User & Calibration Manual

[safety] Safety Directions
PRECAUTIONS
The product must not be disposed with household waste.
Dispose of the product appropriately in accordance with the national regulations in force in your country.
ELECTROMAGNETIC COMPATIBILITY (EMC)
Description
The term Electromagnetic Compatibility is taken to mean the capability of the product to function smoothly in an
environment where electromagnetic radiation and electrostatic discharges are present, and without causing
electromagnetic disturbances to other equipment.
WARNING
Electromagnetic radiation can cause disturbances in other equipment. Although the product meets the strict
regulations and standards which are in force in this respect, the manufacturer cannot completely exclude the
possibility that other equipment may be disturbed.
CAUTION
There is a risk that disturbances may be caused in other equipment if the product is used in conjunction with
accessories from other manufacturers, for example field computers, personal computers, two-way radios,
nonstandard cables or external batteries.
Precautions:
Use only the equipment and accessories recommended by the manufacturer. When combined with the product,
they meet the strict requirements stipulated by the guidelines and standards. When using computers and two-way
radios, pay attention to the information about electromagnetic compatibility provided by the manufacturer.
CAUTION
Disturbances caused by electromagnetic radiation can result in erroneous measurements. Although the product
meets the strict regulations and standards within this respect, the manufacturer cannot completely exclude the
possibility product may be disturbed by very intense electromagnetic radiation, near radio transmitters, two-way
radios or diesel generators.
Precautions:
Check the plausibility of results obtained under these conditions.
WARNING
If the product is operated with connecting cables attached at one of their two ends, for example, external supply
cables, interface cables, the permitted level of electromagnetic radiation may be exceeded and the correct functioning
of other products may be impaired.
Precautions:
While the product is in use, connecting cables, for example product to external battery, product to computer, must be
connected at both ends.
SAFETY LABELS
The One-Dot Laser is a Class 3R laser, manufactured to comply
with the international rules of safety IEC 60825-1, 2001.
Although the power of the emission of the beam is less than
5mW in Class 3R, the following cautions are recommended:
• Do not stare directly at the beam
• Do not set up the laser at eye level
EZDigPro
- 96 -
FCC
Labels
User & Calibration Manual