Bucket Selection - Agatec EZDigPro User & Calibration Manual

[usage]

Bucket Selection

Press to enter the bucket selection page.
Press to change the bucket in use.
Press to return to previous screen. If the bucket number has been changed the following screen will appear:
Press to confirm the new bucket selected and return to previous screen
Press to return to the previous screen and not change the actual bucket (old selected bucket will stay in use)
Note: If you want to calibrate the new bucket doing a whole automatic calibration all sensors (slow method), you have
to choose your new bucket at this page prior to calibration. If you want to calibrate the new bucket using the manual
calibration method (for the bucket only, fast method), you can choose your new bucket (number) during the manual
calibration method.
Note: Even though you might have not moved the bucket sensor after you've changed the bucket (if attached to the
dog bone or quick connector), you still have to calibrate this new bucket.
Be sure to use the correct number in the calibration mode when you're doing the calibration.
EZDigPro
- 73 - User & Calibration Manual