Sensor Assignment - Agatec EZDigPro User & Calibration Manual

Table of Contents

Advertisement

[calibration]

Sensor Assignment

Follow these menu prompts to assign each sensor:
After the sensor assignment – or before the next-day setup – you can verify the sensor assignment per the
Troubleshooting Sensor Reception section on page 92 by rotating a sensor (in vertical) with your hand. The value that
changes the most indicates which sensor you're actually using.
EZDigPro
SENSOR ASSIGNM.
SENSOR ASSIGNM.
Put one sensor
Put one sensor
Horizontal
Horizontal
ENTER: continue
ENTER: continue
ZERO: exit
ZERO: exit
Enter
SENSOR ASSIGNM.
SENSOR ASSIGNM.
Searching
Searching
sensor...
150
sensor...
150
FOUND
Assign to:
Assign to:
Boom 1
Boom 1
Boom 2
Boom 2
Boom 3
Boom 3
Bucket
Bucket
Enter
SENSOR ASSIGNM.
SENSOR ASSIGNM.
Programming...
Programming...
Please Wait
Please Wait
PROGRAMMING
SUCCESSFUL ?
YES
SENSOR ASSIGNM.
SENSOR ASSIGNM.
Sensor
Sensor
programming OK !
programming OK !
ZERO to exit
ZERO to exit
- 27 -
SENSOR ASSIGNM.
NOT FOUND
SENSOR ASSIGNM.
No sensor ready
No sensor ready
to be programmed
to be programmed
ZERO to exit
ZERO to exit
SENSOR ASSIGNM.
NO
SENSOR ASSIGNM.
Programming
Programming
FAIL !
FAIL !
ZERO to exit
ZERO to exit
User & Calibration Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EZDigPro and is the answer not in the manual?

Table of Contents