Agatec EZDigPro User & Calibration Manual page 49

[manual calibration]
BOOM 3 - LENGTH
Boom 3 refers to the dipper stick on excavators with articulated booms (3 booms).
On excavators with conventional booms (boomerang – 2 booms) the
Select (press ) the
Enter
Right.
Measure accurately the length between the center of pivot G and the center of pivot H
Move the cursor to highlight
EZDigPro
Boom 3
BOOM 3 CALIBRAT.
BOOM 3 CALIBRAT.
Side
Side
Length
Length
Angle
Angle
-Offset
-Offset
-Actual
-Actual
Side
where the sensor is installed; viewing the excavator from the cabin: L = Left and R =
Length
and set the exact value expressed in the selected unit of measure.
L
L
6.600
6.600
30.0
30.0
25.0
25.0
0.0
0.0
Fig.7
Length
must be set to "0" (zero).
- 49 - User & Calibration Manual