Set The Depth Reference - Agatec EZDigPro User & Calibration Manual

[usage]

Set the Depth Reference

A
Elevation offset
Press to enter the depth setting mode. The correspondent value will flash.
To set the target depth, use these buttons:
-
Press or
the sign changes!
Press to invert the sign (positive / negative).
Press to fast zero the value.
Press to confirm the value and end the setting mode.
Enter
The shown depth is now the distance from the actual bucket position to the target depth.
If the bucket is higher in respect to the target depth the value is positive and vice-versa.
Note that this value can be affected by other functions; see following pages for details.
EZDigPro
DEPTH
to set the desired value. Note: To go down, dial in a negative value! Once you press
- 66 - User & Calibration Manual
Enter