Table of Contents
Advertisement
Available languages
Available languages
EARTHING INSTRUCTIONS
This washer must be earthed. In the event of a malfunction
or breakdown, earthing will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is
properly installed and earthed in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly earthed.
Do not modify the plug provided with the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
INSTALLATION INSTRUCTIONS
Before You Start
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
NOTE: To avoid floor damage, set the washer onto cardboard before moving across floor.
Remove Shipping Materials
Removing the shipping material is necessary for proper operation. If the shipping material is
not removed, the washer will make excessive noise.
1. Move the washer to within approximately 90 cm (3 ft) of its final location.
2. The washer must be in the upright position and not tilted before removing the shipping
material.
3. Locate the yellow shipping materials on the rear of the machine, near the bottom. Follow
the steps for your particular model, either the one with the straight power cord and cord
restraint or the looped power cord version.
8
Straight power cord
1. Remove power plug and yellow strap from machine base to release the rear leveling
system.
2. Firmly grasp the power cord and pull to completely remove the power cord, cord
restraint, and pin from the rear panel.
Straight power cord
Advertisement
Table of Contents
