A.1 Technical Data - Festo CPX System Manual

A. Technical appendix
A.1 Technical data
General
Temperature range:
Operation
Storage/transport
Relative air humidity
Protection against electric shock
(protection against direct and indirect con
tact as per EN 60204−1/IEC 204)
Protection class as per EN 60 529 (plug con
nector inserted or provided with protective
cap)
Electromagnetic compatibility
Interference emission
Interference immunity
2)
Vibration and shock
Vibration
Shock
Continuous shock resistance
1)
The component is intended for use in industrial environments.
2) See following table for explanations of the severity levels.
3) For MPA valve terminals, the vibration and shock resistance depends on the number of installed
sub−bases (see pneumatic description).
Festo P.BE−CPX−SYS−EN en 0902e
− 5 °C ... + 50 °C
−20 °C ... + 70 °C
95 %, non−condensing
By means of PELV power supply unit
(Protected Extra Low Voltage)
Depending on the connections and configuration
used. The lowest protection class of the weakest
components used is always valid for the complete
device (see manual for the relevant module)
e.g. terminal connections: IP 20
e.g. M8 and M12 connections: IP 65 and IP67
See declaration of conformity (www.festo.com)
See declaration of conformity (www.festo.com)
Tested according to DIN/IEC 68/EN 60068
part 2−6;
When mounted on an H−rail
When fitted on a wall
Tested according to DIN/IEC 68/EN 60068
part 2−27;
When mounted on an H−rail
When mounted on a wall
Tested according to DIN/IEC 68/EN 60068
part 2−29;
With H−rail and wall mountings:
Severity level 1
3)
: Severity level 1
3)
: Severity level 2
3)
: Severity level 1
3)
: Severity level 2
A−3