Fitting A Cpx Terminal (Here With Cpa Pneumatics) Onto An H−Rail - Festo CPX System Manual

2. Assembly
1
H−rail
2
Clamping
component of the
H−rail clamping
unit
3
Retaining screw
of the H−rail
clamping unit
Fig. 2/11: Fitting a CPX terminal (here with CPA pneumatics) onto an H−rail
2−24
Proceed as follows:
1. Make sure that the fastening surface can support the
weight of the CPX terminal.
2. Fit the H−rail (support rail EN 60715 − 35x7.5; width
35 mm, height 7.5 mm).
Make sure there is sufficient space to connect the com
pressed air supply tubing.
3. Fasten the H−rail to the mounting surface at intervals of
approx. every 100 mm.
4. Fit an H−rail clamping unit to both the left and the right−
hand end plates and the pneumatic interface of the CPX
terminal.
5. Hang the CPX terminal onto the H−rail (see Fig. 2/11,
arrow A).
6. Swing the CPX terminal onto the H−rail (see Fig. 2/11,
arrow B). Make sure that the clamping element lies hori
zontally to the H−rail.
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó Ö Ö
Ó Ó Ó Ö Ö
Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Ó Ó Ó
Festo P.BE−CPX−SYS−EN en 0902e
A
1
2
3
B