Dismantling A Module Or Interlinking Block - Festo CPX System Manual

2. Assembly
1
Tie rod
2
Loosened module
Fig. 2/3: Dismantling a module or interlinking block
Assembly
Festo P.BE−CPX−SYS−EN en 0902e
1
7. Carefully remove the loosened module by lifting it up
wards.
To insert a module or interlinking block, proceed as follows:
1. Insert the module in the desired position (see Fig. 2/3).
The tie rod must lie exactly over the tie rod groove.
Caution
When interlinking blocks are arranged in series:
Make sure that the electric plug connectors of the inter−
linking blocks are not bent.
2. Align the CPX terminal on a flat surface so that the compo
nents are not offset. Use the bearing surface for the H−rail
to align the component correctly. It is easier to align if you
use an H−rail. Alternatively, you can place the CPX ter
minal without pneumatics or with the CPA pneumatics in
such a way that the interlinking blocks' electrical connec
tions are facing upwards (see Fig. 2/4). The tie rod is held
in the tie rod groove by the force due to weight.
A
2
2−9