Idle Mode Channel X (Channel−Specific); Force Channel X (Channel−Specific) - Festo CPX System Manual

B. Parameters and data of the CPX terminal
Module parameter: Idle mode channel x
Modules For modules with digital and analogue outputs (see manual for the module)
Function no. Access to these module parameters is made via protocol−specific functions (see
the CPX bus node description).
Description Only relevant for certain fieldbus protocols.
Idle mode channel x: Hold last state
Idle state channel x:
Note With the aid of Idle mode parametrisation, the signal status which the outputs/
valves are to assume during a change into the Idle status can be determined
(see also section C.3.3).
Tab. B/21: Idle mode channel x (channel−specific)
Module parameter: Force channel x
Modules For modules with digital and analogue inputs and outputs (see manual for the
module)
Function no. Access to these module parameters is made via protocol−specific functions (see
the CPX bus node description).
Description Force mode of inputs channel x:
Force state of inputs channel x:
Force mode of outputs channel x: blocked (presetting)
Force state of outputs channel x: Set signal
Note The function Force permits the manipulation of signal states independent of
actual operating conditions (see also section C.3.1).
Tab. B/22: Force channel x (channel−specific)
B−22
Idle state (presetting)
Set output
Reset output (presetting)
For additional channel−specific module parameters as well as
detailed information, see the manual for the relevant module.
blocked (presetting)
Force state
Set signal
Reset signal (presetting)
Force state
Reset signal (presetting)
Festo P.BE−CPX−SYS−EN en 0902e