Fault End Filter; Error Number Filter - Festo CPX System Manual

B. Parameters and data of the CPX terminal
Diagnostic memory parameter: Fault end filter
Function no. 3484
Description Diagnostic memory filter with which you can determine whether running faults
are to be registered or not.
Bit Bit 3
Values

Fault end filter

Bit 3 Description
0 Register running faults (end of fault) (filter inactive,
presetting)
1 Do not register running faults (end of fault) (filter
active)
Note By registering the outgoing fault, you can ascertain how long the fault has
existed. Incoming and running faults each represent one entry. With running
faults the fault number 0" is entered. Maximum 40 entries are saved together.
Tab. B/27: Fault end filter
Diagnostic memory parameter: Error number filter
Function no. 3484
Description With this diagnostic memory filter you can:
Bit Bits 4, 5
Values

Error number filter

FN = error number
Bit 5 4 Description
0 0 Error number filter inactive (presetting)
0 1 Register only defined FN
1 0 Do not register defined FN
1 1 Reserved
Note The error number is determined by means of the diagnostic memory parameter
Error number" (function no. 3487).
Tab. B/28: Error number filter
B−26
Suppress the registering of a desired fault message
Register exclusively a desired fault message
[Fault end filter]
[Rec. outg. faults]
[Do not rec. outg. faults]
[Fault numbers filter]
[Inactive]
[Rec. only def. FN]
[Do not rec. def. FN]
−
Festo P.BE−CPX−SYS−EN en 0902e