Pre−Assembling The Plugs And Cables; Individual Parts Of The Socket And Cable Exit - Festo CPX System Manual

3. Installation
Pre−assembling the plugs
and cables
1
Cable
2
Strain relief
3
Housing
4
Connecting part
Fig. 3/1: Individual parts of the socket and cable exit
Festo P.BE−CPX−SYS−EN en 0902e
Connect the plugs and cables as follows (example):
1. Open the plugs/sockets as follows:
Power supply socket:
·
Insert the mains power socket into the operating volt
age connection of the CPX terminal. Unscrew the
housing of the socket.
Then remove the connecting part of the socket, which
is inserted in the operating voltage connection.
Fieldbus socket and sensor plug (only with PG...):
·
Loosen the centre knurled nut.
1
4
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
3. Remove 5 mm of insulation from the end of the conduc
tors and fit cable−end sleeves on the stranded wires.
4. Connect the ends of the conductors.
2
3
3−5