Secondary C300 Block; Main Tab; Redundancy Tab; Ceec300 Function Block - Honeywell Experion C300 User Manual

Secondary C300 Block

Main Tab

Plain Text
Date Last Modified
Secondary C300 Block
The Secondary C300 Controller block is available when the 'Module is redundant'
(MODISREDUN) check box is checked on the Primary C300 configuration form Main
tab. The Secondary C300 configuration form contains the same tabs and parameters as
the primary with the exception of a few parameters on the Main and Redundancy tabs.
The differences are described in the following paragraphs.
Main Tab
The Main Tab of the Secondary C300 Controller's configuration form does not contain
the 'Module is redundant' or 'Secondary Tag Name' fields. All other parameters
contained on the Primary's main tab are present on the secondary's main tab. Parameters
in the Advanced Configuration subgroup are copied from the primary block to the
secondary block and are view only on the secondary's form.

Redundancy Tab

The Redundancy Tab of the Secondary C300 block contains the parameter 'Last Block
Migrated' (LASTOPMNAME) which is not applicable on the Primary C300 block.

CEEC300 Function Block

The CEEC300 function block is created when a new C300 Controller block is created
and configured in the Project tree in Control Builder. The following sections identify and
describe all user-visible parameters associated on the CEEC300 configuration form. For
more details about these parameters see the Control Builder Parameter Reference.
Main Tab
The Main tab is used for the configuration of the CEEC300 block. See
CEEC300 Function Block
displays important state information and supports generation of commands to the
106
Parameter Name
VERSIONDATE
for the steps to configure a CEEC300 block. This tab also
Experion C300 Controller User's Guide
Honeywell
User
Configurable
version of block.
No Shows date and time last
modification was made to
block's configuration. If this
block is in Version Control
System, modification date
and time applies to last
version of block.
Notes
To configure a
R301.1
11/06