Cee Icon States In The Monitoring Tab; Initiating C300 Controller Shutdown - Honeywell Experion C300 User Manual

Initiating C300 Controller Shutdown

CEE Icon states in the Monitoring tab

Step
Alternate methods:
• Click the Toggle State
−
CEE Icon states in the Monitoring tab
The CEE status in the monitoring tab is indicated by the following versions of the CEE
icon.
CEE Icon States
1. Project Tree
2. Loaded, not monitoring
3. Communication Failure
4. InActive
5. Active
6. Configuration Error
Initiating C300 Controller Shutdown
Use the following procedure to initiate a shutdown command to the C300 Controller,
which results in the C300 Controller rebooting to its RDY state or boot firmware.
ATTENTION
Shutting down the C300 Controller, interrupts the transfer of data to the
Experion system. Be sure your system can tolerate the loss of live data, while
the C300 Controller is in its RDY state.
Step
1
Using Control Builder, select the Monitoring tab –
Double-click the C300 Controller icon to open the C300 Block configuration
176
toolbar button to set the selected item inactive.
Select Operate -> Change State
Icon Color
Gray
Gray
Red
Blue
Green
Red
Experion C300 Controller User's Guide
Honeywell
Action
Corresponding CEESTATE Values
N/A
N/A
N/A
CEESTATE = IDLE
CEESTATE = RUN
CEESTATE = FAIL, NOT_LOADED
Action
R301.1
11/06