Table 9 C300 Controller Faceplate Display Indications - Honeywell Experion C300 User Manual

The controller's operating state the display shows in a rotating display the FTE
•
Device Index, CEE state, and soft failures (such as redundancy, communications, or
diagnostic faults).
The controller's redundancy role and synchronization status.
•
Fault codes when the controller ceases normal operation due to a major fault.
•
Table 9 includes a listing and descriptions of the various indications of the C300
Controller display.

Table 9 C300 Controller faceplate display indications

Faceplate
Display
(####) Communication Failure – No effect on controller state,
See Note 1 shown on Control Builder forms and Station displays
Tnnn POST test number – Transient state, No CDA.
-BP- Controller in BootP mode waiting for IP address -
Transient state, No CDA.
-TS- Controller is attempting connection to time server, or time
server is not available – Transient state, No CDA.
COMM Controller not able to communicate with other nodes.
See Note 2
TEST Factory Test mode – Non product state, No CDA.
FAIL Failure in Module – No CDA
See Note 3
ALIV Boot mode with no application image – No CDA
RDY Boot mode with application image – No CDA
LOAD Firmware load in progress – No CDA
PROG Firmware flash in progress – No CDA
NODB Application mode with no database – CDA present
NOEE Application node with no CEE, but C300 FB present with
CDA. This is a transient state during loading C300 FB or
when deleting CEE FB/C300 FB
R301.1
11/06
Indicates...
Experion C300 Controller User's Guide
Honeywell
C300 faceplate indicators/displays
Faceplate display information
C300 Module
(PCMSTATE)
OFFNET
N/A
BOOTING
BOOTING
OFFNET
TESTING
FAILED
ALIVE
PIREADY
LOADING
LOADING
NOTLOADED
NOEE
State
165