Using Ctools To Capture Diagnostic Data - Honeywell Experion C300 User Manual

Fault
Classification
Installation /
Startup Failure
Hardware
Watchdog Timer
Expired
Communications
Failure

Using CTools to capture diagnostic data

You can use the CTool utility to capture diagnostic data used to examine the operating
conditions within the controller. This data also can be analyzed to determine the cause of
an error or fault. The following data can be captured using CTools:
Trace Log
•
Registers
•
SSP
•
Call Stack
•
Instructions
•
See Series C Firmware Load Tool (CTool) for Series C Components in the Control
Hardware Troubleshooting and Maintenance Guide for the procedure to capture
diagnostic data.
R301.1
11/06
Controller display
<Rdn State>
<DeviceIndex>
<CEE State>
-SF -
Tnnn indicating the test
number that the controller
was performing when a fault
was detected.
-bp- BootP service not
available
-TS- Time source not
available.
Blank
COMM indicating no
communications with other
nodes.
Experion C300 Controller User's Guide
Honeywell
Using CTools to capture diagnostic data
LEDs
blinking off once per second
Status LED = solid RED
Status LED = RED blinking
off every 1/8 second.
FTE LEDs = RED
FTE LEDs = RED
Initial checks
219