Assign Control Modules And Ioms To A Ceec300 Block - Honeywell Experion C300 User Manual

Assign Control Modules and IOMs to a CEEC300 block

To create and save a Control Module.
Step
Note: If the Control Module's chart is NOT open in the control drawing area,
right-click on the new Control Module in the Project Tree to display the
selection options and click on Module Properties... to open the Control
Module parameter configuration form for input.
3
Enter a new Control Module name in the Name field along with a description
in the Description field.
4
Using the F1 key to access context-sensitive Help, fill in the remaining fields
as required.
5
Click OK.
Configuration form closes.
6
If necessary, double-click on the newly-named Control Module in the Project
Tree to open it. The new name appears at the top of the Control Module
drawing when the control drawing opens.
7
Click File -> Save to save any additional changes you make to the Control
Module before closing.
8
Click File -> Close to close the chart.
Assign Control Modules and IOMs to a CEEC300 block
Once a Control Module (CM) or Sequential Control Module (SCM) is created, you can
assign it to a CEEC300 block of a C300 Controller. Use the following procedure as a
general guide to assign configured CMs and I/O Modules (IOMs) to the CEEC300 block.
Note that in the C300 controller environment, Chassis IOMs and Rail IO modules can be
assigned only to the CEEC300 block.
60
Action
Experion C300 Controller User's Guide
Honeywell
R301.1
11/06