IOTA. Two Control Firewall assemblies are required to provide network redundancy,
(one CF9 supports the FTE "A" segment and the second supports FTE "B" segment).
Eight ports on each control firewall provide connection for up to eight FTE nodes. A 9
port provides an uplink to the supervisory FTE network and level 2 control.
See the Control Firewall User's Guide for details about the Control Firewall installation.
Series C I/O modules installation
See the Series C I/O User's Guide for details about the various Series C I/O modules and
their installation
Series C FIM installation
See the Series C Fieldbus Interface Module User's Guide for details about the Series C
FIM modules and its installation.
Upgrading C300 Controller Firmware
The Series C Firmware Load Tool (CTool) utility is used to efficiently upgrade firmware
in Series C control hardware components.
Refer to the Upgrading Firmware in Series C Components section in the Control
Hardware and I/O Module Firmware Upgrade Guide in Knowledge Builder for details
about using CTool to upgrade firmware in Series C components. For more information
about the CTool utility, refer to the Series C Firmware Load Tool (CTool) for Series C
Components section in the Control Hardware Troubleshooting and Maintenance Guide
in Knowledge Builder.
Using the Controller Migration Wizard
If you have Series C Controllers which are configured and loaded, you can use the
Controller Migration Wizard to update you control component's firmware in an On-
Process or Off-Process fashion to the latest release version or to a service pack or point
release. Note that you must have Control Builder to use this application. See the
Experion Migration User's Guide as well as the Control Builder on-line help for the
Controller Migration Wizard for more information.
C300 Controller behavior during firmware upgrade and timeout
The following indications are shown on the faceplate display of the C300 Controller
during the firmware upgrade operation.
The display shows LOAD while the firmware image is being loaded to the controller
•
R301.1
11/06
Experion C300 Controller User's Guide
Honeywell
Series C I/O modules installation
Using the Controller Migration Wizard
th
31