Charging The Battery - AEMC PowerPad IV Quick Start Manual

Charging the Battery

Following shipping safety protocols this unit's battery is charged to only 30%.
Before using the instrument, you must fully charge the battery.
1. Remove the plastic film between the battery and instrument.
2. Connect the power cord to the power supply unit using the supplied adapter.
3. Plug the power cord into an outlet.
4. Open the elastomer cover that protects the power socket.
5. Connect the power supply's 4-point connector to the instrument.
The ON/OFF button
charging status.
When the battery is fully depleted, the charging time is approximately 6 hours.
The ON/OFF button
Description
Measurement Terminals
4 current input terminals
(for current sensors)
N
Power Quality Analyzer PowerPad
will blink while charging, and the display will indicate the
will glow steady green when the battery is fully charged.
L1 L2 L3
IV Model 8345 Quick Start Guide
®
120 V ± 15 %, 60 Hz
230 V ± 15 %, 50 Hz
5 voltage input terminals
1000V CAT IV
GND
N L1
L3
L2
7