Installation And Connection Of Auxiliary Equipment And Options; Machines With Rinse Cleaning Functions; Limit Switch; Conveyors - Wexiodisk WD-153 optiflow Installation And User Manual

Installation instructions

3.6 Installation and connection of auxiliary equipment and options

•
•
•
The various options normally place no specific requirement on the installation.

3.6.1 Machines with rinse cleaning functions

•
•

3.6.2 Limit switch

The Limit switch is installed on the lower terminal block, which is placed in front
of the chemical wash tank. When connecting, remove the existing clamp on the
connection points. See the machine's wiring diagram. N.B.! The machine's volt-
age is 24V.

3.6.3 Conveyors

Installation of in- and outfeed equipment (conveyors, curves) must be performed
in accordance with the wiring diagram's main circuit instructions. This applies to
machines equipped with a motor switch and contactors for this equipment.
Connection of supply voltage to the in- and outfeed equipment is performed in ac-
cordance with the wiring diagram's instructions. N.B.! The machine's voltage is
24V.
When fitting a motor switch and contactors retrospectively, use the components
on the wiring diagram and follow the connection instructions. This affects the
manufacturer's liability - see "SAFETY INSTRUCTIONS".

3.6.4 Emergency stop

An additional emergency stop can be connected at the lower terminal block,
which is placed in front of the chemical wash tank. Replace the existing clamp on
the connection points when connecting a new emergency stop. See the ma-
chine's wiring diagram. N.B.! The machine's voltage is 24V.
WD-153 - WD-423
Once the machine is in place and has been adjusted horizontally and ver-
tically, the auxiliary equipment can be fitted.
The machine can be equipped with a number of options. Check what your
machine is equipped with, which depends on the model, machine type and
country.
The machine comes ready for the connection of WD-PRM60/90. Loop X20
(see the machine's wiring diagram) must be removed when WD-PRM60/
90 is retrofitted.
The machine should be connected to hot water for optimum functioning.
It is possible to connect detergent to this function; this is done using the
rinse cleaning valve.
29
optiflow
Rev. 00 (202310)