Installation; Installation Overview - Extron electronics MKP 2000 User Manual

Installation

This section describes the installation of the MKP 2000, including:
•
•
•

Installation Overview

ATTENTION:
ATTENTION : Risque de dommages matériels : L'installation et la maintenance du
Install and set up the MKP 2000 as follows:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
4 MKP 2000 • Installation
Installation Overview
Installation
Rear Panel and Side Panel Connections
Risk of property damage: Installation and service must be performed by
authorized personnel only. This product should be used with a UL approved electrical
box.
système doivent être exclusivement effectuées par le personnel autorisé. Ce produit
devrait être utilisé avec un boîtier électrique certifié UL.
Turn off all equipment and disconnect it from the power source.
Install the cables to and from the control panel in a wall, podium, or desk (see
Panel and Side Panel Connections
Prepare the wall, podium, desk, or other surface to mount the MKP (see
the site and installing the mounting bracket (mud ring) or wall box
page 6).
Install the control panel in a wall, podium, desk, or other surface (see
the MKP to the mounting bracket (mud ring) or wall box
Connect the input and output cables (see
Connections for guidelines).
Connect the power supply (see
Connect power cords and turn on the equipment in the following order:
Output devices such as projectors or monitors
•
Connected matrix switcher
•
Input devices such as DSSs or cable boxes
•
If necessary, set the control panel and matrix switcher IP parameters (see
Viewing and configuring the IP and MKP setup parameters
System Settings Page on page 35).
If necessary, set the control panel RS-232 port for pass-through or no-pass-
through mode, and specify whether the MKP is the primary device (connected to the
switcher) or the secondary device (connected through another device) (see
and configuring the IP and MKP setup parameters
Program the control panel with the size of the connected switcher (see
Settings Page).
on page 9 for guidelines).
Rear Panel and Side Panel
Power Supply Wiring on page 13).
or System Settings
Rear
Preparing
on
Mounting
on page 9).
on page 18 or
Viewing
Page.
System