Host Control Port Setting And Pass-Through Communications - Extron electronics MKP 2000 User Manual

2.
3.
4.
5.
6.
7.
8.
9.
10.

Host control port setting and pass-through communications

•
•
•
20 MKP 2000 • Operation
Use the and
Input Output
Press the button to clear the octet to
Cancel
Use the through buttons to enter the desired octet value.
0 9
Repeat steps 2 through 4 to select and change other addresses and/or octets.
Use the button to select the host control setting display (see figure 21).
Input
Press the Output button until Input and
Output LEDs both light steadily.
INPUT
n
OP
No
Pass-through
INPUT
OUTPUT
OUTPUT
Figure 21. Selecting the Host Control Setting
If necessary, use the
Output
through and no pass-through.
Use the button to select the connection priority display (see figure 22).
Input
Press the Output button until Input and
Output LEDs both blink.
INPUT
Pri
Connected to
Switcher
INPUT
OUTPUT
OUTPUT
Figure 22. Selecting the Connection Priority Setting
If necessary, use the
Output
primary and secondary.
When all addresses, octets, the host control setting, and the priority settings are
correct, press the button.
Take
When the MKP is connected to a computer or control system via its Host RS-232 port
and in pass-through mode, the MKP redirects valid matrix switcher SIS commands that
it receives on its Host RS-232 port to its Switch RS-232 port.
When the MKP is connected to a computer or control system via its Host RS-232 port
andin no pass-through mode, the MKP acts on all valid MKP commands received. It
does not pass the command to its Switch RS-232 port.
When the MKP is selected as primary, the MKP directly controls the matrix switcher
via its Switch RS-232 port or LAN port. Selected as secondary, the MKP controls the
matrix switcher through connection to the primary MKP IP address.
buttons to select and display the desired address and octet.
.
000
PAS
Port
Pass-through
OUTPUT
button to toggle the host control setting between pass-
SEC
Control Though
Primary (RS-232)
OUTPUT
button to toggle the connection priority setting between